View larger

ToolBox Original Multi-Use Adhesive and Sealant 400g

Part Number:

Tool Box™ is an MS polymer, moisture curing adhesive and sealant in one that cures to form a tough, water resistant seal.

Tool Box™ adheres to a wide variety of materials and is a true ‘tool box’ in a cartridge.

Sticks and seals just about anything
Interior/exterior
Paintable with most water-based paints
Rapid skinning and curing
Non toxic; isocyanate and solvent free
Resistant to salt and chlorinated water
Mould resistant

Tool Box™ is an MS polymer, moisture curing adhesive and sealant in one that cures to form a tough, water resistant seal.

Tool Box™ adheres to a wide variety of materials and is a true ‘tool box’ in a cartridge.

Sticks and seals just about anything
Interior/exterior
Paintable with most water-based paints
Rapid skinning and curing
Non toxic; isocyanate and solvent free
Resistant to salt and chlorinated water
Mould resistant

Downloads

Technical Details

Box Quantity : 20
Material : Polymer
Single Units : Yes
Weight : 400g

Product Information

Tool Box™ is an MS polymer, moisture curing adhesive and sealant in one that cures to form a tough, water resistant seal.

Tool Box™ adheres to a wide variety of materials and is a true ‘tool box’ in a cartridge.

Sticks and seals just about anything
Interior/exterior
Paintable with most water-based paints
Rapid skinning and curing
Non toxic; isocyanate and solvent free
Resistant to salt and chlorinated water
Mould resistant

[ Substrates ]

Galvanized Iron
Glass
Aluminium
Ceramic
Plasterboard
Timber
Cement
Fibreglass
Steel
Plastics (pre-test)
Polystyrene

Not recommended for: submerged or constant water immersion, structural bonding.

[ Uses In ]

Sealing lap joints in box guttering
Sealing air conditioning ducts
Adhesive for fixing wall panels to studs, floor boards to joists
Re-fixing loose ceramic tile
Adhering and sealing acrylic/ABS shower units
Adhering end-caps to retaining walls
Sealing gaps and expansion joints in concrete, brick, mortar, metal and stonework

[ How to ]

All surfaces must be clean, dry, sound and free of dust, oil, old sealant or other contamination. For best results wipe all surfaces with isopropyl alcohol (IPA), using a lint free cloth. Manufacturers of plastics should be consulted about suitable cleaning solvents. Adhesion to plastics should be pre-tested if in doubt.

Application: Cut tip off cartridge, fit nozzle, load into H.B. Fuller caulking gun and trim nozzle to desired size.

Adhesive - apply to one surface, press together the components. When used as an adhesive, ensure at least 2mm bond thickness is formed, do not clamp or use excessive force otherwise adhesive will be squeezed from join. Support until a strong bond is formed.

Sealant - When used as a sealant, apply Tool Box™ and within 10 minutes tool off to a smooth finish using a spatula. Tool Box™ cures by reaction with moisture, so encapsulation between non porous surfaces will delay or suppress cure from occurring.